MC-2010MN
pre-formed rubber strip
20mm X 10mm
(0.79" X 0.39" - 3/4" X 3/8")
(embedded wire mesh )

Minimum use Conditions:
*Wall/slab thickness greater than 9.0" (10.0" recommended)
*Minimum 4" concrete coverage
6.5 ft wall height (check with representative for variations)
*Between double row of rebar
*Below grade or water present either side of wall/slab joint

Benefits - "NSF CERTIFIED"
*Withstand high hydrostatic head
*Withstand intermittent exposure to rain or water
*Expands up to 2 times by volume
*Embedded wire mesh promotes vertical expansion vs longitudinal
*Attach with screws, nails, glue,(P-201 on rough concrete with nails or screws)

NSF approved for potable water

MC-2005M
pre-formed rubber strip
20mm X 5mm
(0.79" X 0.20" - 3/4" X 3/16")
(embedded wire mesh )

Minimum use Conditions:
*Wall/slab thickness greater than 9.0" (10.0" recommended)
*Minimum 4" concrete coverage
6.5 ft wall height (check with representative for variations)
*Between double row of rebar
*Below grade or water present either side of wall/slab joint
*HYDROSTATIC HEAD LESS THAN 50 FEET

Benefits
*Withstand intermittent exposure to rain or water
*Expands up to 2 times by volume
*Embedded wire mesh promotes vertical expansion vs longitudinal
*Attach with screws, nails, glue,(P-201 on rough concrete with nails or screws)

KBA-1510FP
pre-formed rubber strip
15mm X 10mm
(0.60" X 0.40")

Minimum use Conditions:
*Wall/thickness greater than 4.0"
*Minimum 1" concrete coverage
*Use with single row of rebar or double row of rebar
*Below grade or water present either side of wall/slab joint
*Hydrostatic head less than 25 feet

Benefits
*Can be used outside of rebar
*Low expansion pressure can be used with limited concrete coverage (1.0")
*Expands approximately 25% by volume
*Attach with glue, butyl rubber paste or P-201 with screws
*Use in containment dikes