- Adeka Ultra Seal P-201 Container size: 3.17 gal (12 liter) pail - 320 ml cartridge
- Viscosity of Adeka Ultra Seal : P-201 = 15,000 cps ; Viscosity at 25 degrees C ; Type E 5rpm ; 150 PaS;1PaS=100mPaS=100cps
- Apply through pump at approximately 50 psi (3.5 BAR).
- Apply at above 40 deg. ambient and material temperature.
- Clean interlock thoroughly with wire brush. Blow out with compressed air.
- One gallon of P-201 will cover approximately 90 feet of interlock.
- Approximately 650 lineal feet can be treated in one eight hour shift.
- Inspect interlock after treatment and use brush to touch up manually if necessary.
- Clean equipment with MEK (methyl ethyl ketone) or methylene chloride (check and use manufacturers precautions when handling this solvent).
- Allow 2 days for complete polymerization.
- Piles are best stored with treated interlock in an inverted position. Keep dry during storage and transporation.
- Drive with untreated interlock leading.
- Driving must be complete within 2 hours once pile is in water (ground water).
- Piles can be driven with impact hammer or vibratory drivers. Interlocks temperature should not exceed 270 degrees F. during driving process.
- Panel driving can be accomplished if the ground water level is low and piles can be staggered. Once in ground water, they must reach final level within 2 hours.
- Call 800.999.3959 and request free CD or VHS video of Roxan System installation.
|
